Operating Modes & Programming

General Warnings

• Usually, the receiver and transmitter are paired at the factory. If not, reprogram them.
• Reset before changing the operating mode.
• After reset, all remote controls will no longer work.
• Replace the battery in time when the remote transmitter voltage is low for stronger signal transmission.
• Slightly stretch the antenna on the receiver for better signal reception.
• The remote transmitter needs 2 or more buttons to set up in latched mode.
• The output type is passive output / potential-free contacts

Momentary Mode

Operation: Press and hold the button, the relay turns on; release the button, the relay turns off.

How to Program:

1. Press the learning button (on the receiver) 1 time. The indicator LED on the receiver lights up.
2. Press one button on the remote transmitter. The indicator LED on the receiver flashes several times and then lights down. Success

Toggle Mode

Operation: Press button "A", the relay turns on; press button "A" again, the relay turns off.

How to Program:

1. Press the learning button (on the receiver) 2 times. The indicator LED on the receiver lights up.
2. Press one button on the remote transmitter. The indicator LED on the receiver flashes several times and then lights down. Success.

Latched Mode

Operation: Press button "A", the relay turns on; press button "B", the relay turns off

How to Program:

1. Press the learning button (on the receiver) 3 times. The indicator LED on the receiver lights up.
2. Press button "A" on the remote transmitter. The indicator LED on the receiver flashes several times and then lights up.
3. Press button "B" on the remote transmitter. The indicator LED on the receiver flashes several times and then lights down. Success.

Delay Mode

Operation: Press and hold a button, the relay turns on; release the button, the relay turns off after 5 seconds (10/15/20 seconds).

How to Program:

1. Press the learning button (on the receiver) 4 times (or 5/6/7 times). The indicator LED on the receiver lights up.
2. Press one button on the remote transmitter. The indicator LED on the receiver flashes several times and then lights down. Success

Reset

Press the learning button (on the receiver) 8 times. The indicator LED on the receiver flashes several times and then lights down. Success.